fansple.blogg.se - Download hexbug witch doctor

Gently remove the entire circuit board and the electronics along with the power button.Disassemble the SawBlaze arm and remove the motor.Store the harvested screws in a magnetic container.

Note: The middle wedge of the Hexbug SawBlaze is attached to this top section, so if you leave that in, you can use that as a grabbing point to remove the top.Undo the bottom screws and carefully pull out the top section.If you accidentally make the slots too large, the axle will fall out of alignment and completely screw over your drive train. Prepare the chassis and top plate by gently filing the axle slots a tiny bit.

Paint the printed parts before doing any assembly.

Note: You'll need to use your slicing software's "mirror" function on each wedge part once in order to actually get the complete wedge.

Buy a Hexbug Witch Doctor V1, Witch Doctor V3, SawBlaze, and a 9g servo.

You will absolutely need to make use of this guide video as well as the following instructions. If you decide to build this, it will be your most expensive kitbash yet as you need 3D printing and three different donor Hexbugs for this one as well as a 9g servo typically found in 150g fairyweights. Witch Doctor is a 4WD vertical spinner with a functional self-righter.